Argo LUDVIG Інструкція з експлуатації Посібник з експлуатації - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Кондиціонер Argo LUDVIG. Argo LUDVIG 20 сторінок.
Друкувати сторінкуThis appliance can be used for cooling, dehumidifying and ventilating. When switching between modes, the fan
continues to rotate but the compressor stops: the compressor will start after 3 minutes. This delay protects the compressor
from potential damage.
Cooling, Fan
THE DRAINAGE TUBE MUST BE CONNECTED to the appliance AT ALL TIMES: the only exception is when the
appliance is used in dehumidification mode only, in which case the appliance should be left to discharge directly
into the room for maximum efficiency (see the "Dehumidification Mode" paragraph).
Clean the air filters under the easily removable rear grille regularly to keep the air conditioner working efficiently.
1. COOLING MODE (COOL)
•
The "Cool" LED on the control panel will turn on.
•
The temperature can be adjusted to between 16 °C and 32 °C.
•
In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the
temperature setting and retains this setting when it is switched on again.
•
In this mode, the fan speed can be adjusted and the Timer and SLEEP functions can be set.
•
For more silent operation, run the fan at low speed.
2. DEHUMIDIFICATION MODE (DRY)
•
Press the MODE button to select the dehumidification mode.
•
The temperature is controlled by the electronic board and cannot be adjusted.
•
In this mode, each time the ON/OFF button is pressed the unit switches off, the appliance saves the settings
and retains them when it is switched on again.
•
The fan speed is set to low and cannot be adjusted.
NOTE: the air conditioner does not cool the room when operating as a dehumidifier. When the appliance is
used as a dehumidifier, the flexible pipe must not be connected. For maximum dehumidification efficiency, leave
the rear discharge attachment free to discharge directly into the environment. The dehumidification mode is
recommended during autumn and winter. If used during summer, it is best to leave the flexible pipe attached so
that the hot air is discharged towards the outside rather than into the room. During dehumidification, continuous
drainage should be implemented (see the next chapter, "HOW TO ELIMINATE CONDENSATE").
3. FAN MODE (FAN)
•
Press the MODE button to select ventilation until the corresponding icon appears.
•
In this mode, the fan speed can be adjusted.
•
The temperature cannot be adjusted.
V 04/23
HOW TO USE THE APPLIANCE
OPERATING MODES
Dehumidifying
29