Argo Nuk Інструкція з експлуатації Посібник з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Кондиціонер Argo Nuk. Argo Nuk 13 сторінок. Local

Connect the power cord to a suitable electrical socket (220-240 V). Insert the batteries supplied into the remote control,

while observing the polarities. Select the desired operating mode from the remote control.

This appliance can be used for cooling, dehumidifying and ventilating.

When switching between modes, the fan continues to rotate but the compressor stops: the compressor will start after 3

minutes. This delay protects the compressor from potential damage.

Cooling, Ventilation

THE DISCHARGE TUBE MUST ALWAYS BE CONNECTED to the appliance: the only exception is when the

appliance is used solely for dehumidification, in which case it is advisable to let the appliance discharge directly

into the environment for maximum efficiency (consult the "Dehumidification Mode" paragraph).

Regularly clean the air filters beneath the easily removable rear grille to keep the air conditioner working efficiently.

1. COOLING MODE (COOL)

 The "Cool" LED on the control panel will turn on.

 The temperature can be adjusted to between 16 °C and 31 °C.

 In this mode, the fan speed can be adjusted and the Timer function can be set.

 For more silent operation, run the fan at low speed.

2. DEHUMIDIFICATION MODE (DEHUM)



Press the MODE button to select Dehumidification.



The temperature is automatically set 2 degrees below the room temperature.



The fan speed is set to low and cannot be adjusted.

NOTE

The air conditioner does not cool the room when it is used as a dehumidifier.

When the appliance is used as a dehumidifier, the flexible hose must not be connected.

For maximum dehumidification efficiency, leave the rear discharge attachment free to discharge directly into

the environment.

The dehumidification mode is recommended during autumn and winter.

If used in summer, it is best to leave the flexible hose attached so that the hot air can be discharged towards

the outside rather than into the room.

3. VENTILATION MODE (FAN)



Press the MODE button to select Fan and wait until the relative icon appears.



In this mode, the fan speed can be adjusted.



The temperature cannot be adjusted.

V 01/18

HOW TO USE THE APPLIANCE

Dehumidification