Argo POLIFEMO SLIM Інструкція з експлуатації Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Кондиціонер Argo POLIFEMO SLIM. Argo POLIFEMO SLIM 12 сторінок. Evaporative air cooler
Друкувати сторінку
SPEED BUTTON
With the unit on, press the Speed button, the corresponding LED
to set the desired fan speed from 1 to 24 speeds, the interval at each pressure is 1 speed step In mode Normal each
pressure of the + or - keys corresponds to the interval of 1 up to 24 speed steps, while in Natural and Sleep mode, the
steps correspond to 8 speeds at each pressure, therefore it will be possible to set speeds 8, 16, 24, which correspond
respectively to low, medium and high ventilation speed. The selected speed appears on the display.
If no further selections are made within 5 seconds or if no other buttons are selected (except the ON / OFF button), the
selection will be canceled and the unit will continue to operate with the set ventilation speed.
With the unit on, keep the Speed button pressed for 3 seconds to activate the ventilation, the LED
display and continues to operate in this mode for 20 minutes. During ventilation mode, the buttons are inoperative, with
the exception of the Fan speed and Power button. To deactivate the ventilation, press and hold the Fan speed button for 3
seconds. After 20 minutes of operation, the device automatically turns off and goes into stand-by mode.
TIMER BUTTON
With the unit on, press this button to select the operating range of the appliance, the LED
Then press the + or - buttons to set the operating interval from 1 to 12 hours. Each selection of the + or - buttons
corresponds to 1 hour. The set interval appears on the display. If the set interval is 0, the Timer setting will be canceled.
If no further selections are made within 5 seconds (except for the Power button) the selected operating interval will
remain set. During operation, the display will show the time remaining until shutdown and the fan speed every 10
seconds. When the selected interval is reached, the unit automatically switches off and goes into stand-by mode.
SWING BUTTON
With the unit on, press this button to activate the oscillation of the air delivery grille, the corresponding LED on the control
panel will turn on. To turn off the swing function, press this button again
COOL / HUMIDIFIER BUTTON
With the unit on, press this button to activate the COOL (cooling) / Humidifier (humidification) function.
The corresponding LED on the control panel lights up. To deactivate the function, press this button again.
RAPID DETECTION OF THE WATER LEVEL IN THE TANK
When the unit is started in cooling mode, it generally takes 50 seconds to detect any lack of water in the tank: at this point an
acoustic signal is emitted that repeats 10 times, the water pump stops and therefore also the cooling function.
If there is not enough water in the tank, it signals the lack of water with a 5-second beep.
MEMORY FUNCTION
With the power cord connected, when you turn on the unit by pressing the ON / OFF button, it will start to work with the last
settings selected before turning off, with the exception of the Timer and Sleep functions, which cannot be stored.
When the unit is switched on again, it will operate at medium ventilation speed, and then switch after 3 seconds to the
ventilation mode selected before switching off.
PARTIAL DISPLAY LIGHTING DEACTIVATION FUNCTION
If no selection is made on the control panel, after 1 minute the intensity of the display lighting is reduced to 30%: by touching
any key, the LEDs return to full light intensity.
To activate this function from the remote control or from the appliance, press and hold this button
for 3 seconds, the display turns off completely.
V 01/21
lights up on the display, then press the + - buttons
flashes on the
lights up on the display.
on the remote control
18