Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor Посібник з встановлення обладнання - Сторінка 19

Переглянути онлайн або завантажити pdf Посібник з встановлення обладнання для Мережеве обладнання Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor. Cisco 15530-LCMB-0200 - ESCON Multiplexing Line Card Multiplexor 36 сторінок. User guide

Друкувати сторінку

Chapter 2

Installing the Cisco ONS 15530

Figure 2-14

Step 3

Twist the cable to secure it in the SFP.

Step 4

Install the SFP by inserting it in the muxponder.

Tip

In an unlikely event of the pull-tab is damaged or missing, use a screwdriver to push on the hinge pin to

unlock the SFP cage latch and pull the SFP out from SFP port

Removing SFP from Aggregation Cards and Muxponders

The SFPs used on the aggregation cards and muxponders have different types of connectors. The

different connector types on the SFP optics are:

•

Each connector requires a different method of removal.

Note

Use the show hardware command to see what SFP you have currently installed in your module.

Removing Pull Tab SFPs with RJ-45 Connectors

To remove an SFP with an RJ-45 connector from the muxponder, follow these steps:

Remove the cable from the desired SFP.

Step 1

Use the thumb on your left hand to push against the RJ-45 connector.

Step 2

Use your right hand to pull the pull tab on the SFP.

Step 3

Rotate the SFP while simultaneously pushing against the connector and pulling the pull tab. This

Step 4

releases the SFP from the latch lock of the cage. (See

OL-7706-01

Installing the 15500-XVRA-10E1 SFP

RJ-45 connector (for 8-port multi-service muxponders)

MT-RJ connector (for ESCON aggregation cards)

LC connector (for 8-port FC/GE aggregation cards)

Mini SMB coax connector (for 8-port multi-service muxponders)

Installing and Removing Line Cards or Motherboards

Figure

2-15.)

Cisco ONS 15530 Hardware Installation Guide

2-19