Cisco 2600XM Series Посібник із швидкого старту - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання Cisco 2600XM Series. Cisco 2600XM Series 29 сторінок. Including license and warranty
Також для Cisco 2600XM Series: Посібник із швидкого старту (29 сторінок), Технічний паспорт (6 сторінок), Технічний паспорт (11 сторінок)

Друкувати сторінку

Cisco 2600XM Series Посібник із швидкого старту

Step 3

Enter a host name for the router (this example uses 2610):

Configuring global parameters:

Enter host name [Router]: 2610

Enter an enable secret password. This password is encrypted (more secure) and cannot be seen when viewing the

Step 4

configuration:

The enable secret is a password used to protect access to

privileged EXEC and configuration modes. This password, after

entered, becomes encrypted in the configuration.

Enter enable secret: xxxxxx

Enter an enable password that is different from the enable secret password. This password is not encrypted (less secure)

Step 5

and can be seen when viewing the configuration:

The enable password is used when you do not specify an

enable secret password, with some older software versions, and

some boot images.

Enter enable password: xxxxxx

Enter the virtual terminal password, which prevents unauthenticated access to the router through ports other than the

Step 6

console port:

The virtual terminal password is used to protect

access to the router over a network interface.

Enter virtual terminal password: xxxxxx

Step 7

Respond to the following prompts as appropriate for your network:

Configure SNMP Network Management? [yes]:

Community string [public]:

A summary of the available interfaces appears:

Step 8

The interface numbering that appears is dependent on the type of Cisco modular router platform and on the

Note

installed interface modules and cards.

Current interface summary

Controller Timeslots D-Channel Configurable modes Status

T1 0/0

Any interface listed with OK? value "NO" does not have a valid configuration

Interface

FastEthernet0/0

FastEthernet0/1

Select one of the available interfaces for connecting the router to the management network:

Step 9

Enter interface name used to connect to the

management network from the above interface summary: fastethernet0/0

Step 10 Respond to the following prompts as appropriate for your network:

Configuring interface FastEthernet0/0:

Use the 100 Base-TX (RJ-45) connector? [yes]: yes

Operate in full-duplex mode? [no]: no

Configure IP on this interface? [yes]: yes

IP address for this interface: 172.1.2.3

Subnet mask for this interface [255.255.0.0] : 255.255.0.0

Class B network is 172.1.0.0, 16 subnet bits; mask is /16

pri/channelized

IP-Address

unassigned

Administratively up

OK? Method Status

unset

Prol

dow