Cisco 2691 Series Посібник із швидкого старту - Сторінка 21

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання Cisco 2691 Series. Cisco 2691 Series 29 сторінок. Modular routers
Також для Cisco 2691 Series: Встановлення та форматування (34 сторінок), Технічний паспорт (8 сторінок), Посібник користувача (48 сторінок)

Step 11 The configuration is displayed:

The following configuration command script was created:

hostname 2691

enable secret 5 $1$D5P6$PYx41/lQIASK.HcSbfO5q1

enable password xxxxxx

line vty 0 4

password xxxxxx

snmp-server community public

no ip routing

interface FastEthernet0/0

no shutdown

media-type 100BaseX

half-duplex

ip address 172.1.2.3 255.255.0.0

interface FastEthernet0/1

shutdown

no ip address

end

Step 12 Respond to the following prompts. Select [2] to save the initial configuration.:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started! RETURN

Step 13 The user prompt appears.

2691>

After you complete the initial configuration tasks, your Cisco router is ready to configure for specific functions. See the "Where

to Go Next" section on page 23 for information about locating documentation for advanced configuration procedures.

Initial Configuration Using the CLI (Manual Configuration)

This section shows how to bring up a command-line interface (CLI) prompt for configuration using the CLI, and it directs you

to documentation for the CLI configuration.You can use the CLI if you see the following messages at the end of the startup

sequence:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

If these messages do not appear, SDM and a default configuration file have been installed on the router at the factory. To use

SDM to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager" section on

page 19.