Cisco 3750G - Catalyst Integrated Wireless LAN Controller Посібник для початківців - Сторінка 10
Переглянути онлайн або завантажити pdf Посібник для початківців для Мережеве обладнання Cisco 3750G - Catalyst Integrated Wireless LAN Controller. Cisco 3750G - Catalyst Integrated Wireless LAN Controller 49 сторінок. Integrated wireless lan controller switch
Також для Cisco 3750G - Catalyst Integrated Wireless LAN Controller: Посібник з конфігурації (40 сторінок)
Друкувати сторінку
3. Download the Network Assistant installer, and run it. (You can run it directly from the Web if
your browser offers this choice.)
4. When you run the installer, follow the displayed instructions. In the final panel, click Finish to
complete the Network Assistant installation.
Refer to the Network Assistant online help and the getting started guide for more information.
Command-Line Interface
You can enter Cisco IOS commands and parameters through the CLI. Access the CLI either by
connecting your PC directly to the switch console port or through a Telnet session from a remote PC
or workstation.
Follow these steps:
1. Connect the supplied RJ-45-to DB-9 adapter cable to the standard 9-pin serial port on the PC.
Connect the other end of the cable to the switch console port.
2. Start a terminal-emulation program on the PC.
3. Configure the PC terminal emulation software for:
9600 baud
–
8 data bits
–
No parity
–
1 stop bit
–
No flow control
–
4. Use the CLI to enter commands to configure the switch. See the software configuration guide and
the command reference for more information.
Other Management Options
You can use SNMP management applications such as CiscoWorks Small Network Management
Solution (SNMS) and HP OpenView to configure and manage the switch. You also can manage it
from an SNMP-compatible workstation that is running platforms such as HP OpenView or
SunNet Manager.
The Cisco IE2100 Series Configuration Registrar is a network management device that works with
embedded Cisco Networking Services (CNS) agents in the switch software. You can use IE2100 to
automate initial configurations and configuration updates on the switch.
See the "Accessing Help Online" section on page 36 for a list of supporting documentation.
10