Argo XFETTO DCI HPL Інструкція з монтажу Посібник з монтажу - Сторінка 3
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Кондиціонер Argo XFETTO DCI HPL. Argo XFETTO DCI HPL 17 сторінок. Installation instructions for air conditioner
Друкувати сторінку
PRODUCT IDENTIFICATION
1. Wireless remote control unit
2. Signaling lamps
3. Supply air deflector
4. Lateral air intake grilles
5. Front air intake grille
6. Air filter
7. Electric cable with plug
8. Air inlet hole
9. Air outlet fan
10. Suspension panel
11. Service tube for condensate discharge
12. Tube for condensate discharge
12
SIGNALING LAMPS
1. Receiver : receives signals transmitted from the remote
control.
2. TIMER lamp: This lamp lights up when the system is
being controlled by the timer.
3. STANDBY lamp: This lamp lights up when the air
conditioner is connected to the power and ready to
receive the remote control command.
4. OPERATION lamp: This lamp lights up during operation.
It blinks together with other lamps in case of troubles (see
AUTO-DIAGNOSIS table).
1
11
2
5
6
10
5. Operation button (without remote control): Push the
button to change from one operation mode to the other
(OFF, COOL and HEAT).
WARNING
The OFF position does not disconnect the power. Use
the main power switch to turn off power completely.
NOTES
It is possible to set the air conditioner in order to let
●
the OPERATION, TIMER and STANDBY lamps always
OFF, even during operation.
Press contemporary the IFEEL and FAN buttons on
the remote control unit for more then 5 seconds.
Repeat the same procedure to set again the normal
operation conditions.
In case of troubleshooting the air conditioner
●
diagnostic system activates the lamps accordingly,
even if they are set to OFF. See paragraph
TROUBLESHOOTING for further details.
2
3
4
8
7
9
EG