Cisco 5500 Series Посібник з монтажу - Сторінка 22

Переглянути онлайн або завантажити pdf Посібник з монтажу для Мережеве обладнання Cisco 5500 Series. Cisco 5500 Series 34 сторінки. Cisco 8500 series wireless lan controller
Також для Cisco 5500 Series: Посібник з конфігурації (40 сторінок), Посібник (19 сторінок), Посібник з конфігурації (50 сторінок)

Друкувати сторінку

Unpacking and Installing the Controller

Connecting the Controller's Console Port

Before you can configure the controller for basic operations, you need to connect it to a PC that uses a

VT-100 terminal emulator (such as HyperTerminal, ProComm, Minicom, or Tip).

Note

You can use either the RJ-45 console port or the USB console port (see

The first time that you connect a Windows PC to the USB console port, you are prompted to install the

Note

USB console driver. Follow the installation prompts to install the driver. The USB console driver maps

to a COM port on your PC; you then need to map the terminal emulator application to the COM port.

See the

Follow these steps to connect the PC to the controller's console port:

Step 1

If you use the RJ-45 console port, plug the RJ-45 connector on a null-modem serial cable into the

controller's RJ-45 console port and the other end of the cable into the PC's serial port.

If you use the USB console port, plug the 5-pin mini Type B connector into the controller's USB console

port and the other end of the cable into the PC's USB Type A port.

Start the PC's terminal emulation program.

Step 2

Configure the terminal emulation program for the following parameters:

Step 3

•

Running the Bootup Script and Power-On Self Test

When you plug the controller into an AC power source, the bootup script initializes the system, verifies

the hardware configuration, loads its microcode into memory, verifies its operating system software

load, and initializes itself with its stored configurations. Before performing this test, you should connect

your PC to the controller's CLI console as described in the

section on page

(POST).

Step 1

Plug an AC power cord into the back of the controller and connect the other end to a grounded 100 to

240 VAC, 50/60 Hz electrical outlet.

Turn on the power supply.

Step 2

Step 3

Observe the bootup on the CLI screen.

Cisco 5500 Series Wireless Controller Installation Guide

"USB Console" section on page 4

9600 baud

8 data bits

No flow control

1 stop bit

No parity

22. Follow these steps to run the bootup script and conduct the power-on self test

for more information about the USB console driver.

"Connecting the Controller's Console Port"

Figure

1).

78-18998-01