Argo CLOE Інструкція з експлуатації Посібник з експлуатації - Сторінка 8
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Обігрівач Argo CLOE. Argo CLOE 12 сторінок. Ceramic table fan heater
Друкувати сторінку
c)
The Timer is not active and the LED
d)
Ventilation: active.
e)
Temperature: The default set temperature is 35 ° C.
f)
Oscillation: it is not active and the LED
Press the Power button again to turn off the device and the 60-second countdown appears on the display before entering
standby mode.
2. Heating power button
When the fan heater is on, touch this button on the control panel to select the heating power from low (the corresponding
LED
lights up on the control panel) and high (the corresponding LED
between high and low takes place with a delay of 10 seconds and the low heating power LED is off.
3. SET button
Touch this button on the control panel to select the desired temperature, visible on the display, using the + and - keys, with
an interval of 1 ° C. The temperature can be set from 5 ° C up to 35 ° C.
After setting the desired temperature, touch the SET button on the control panel to confirm the temperature.
The set temperature is displayed if no selections are made within 5 seconds, or if any other keys except + and - are
touched within 5 seconds.
The temperature is not detected on the display for 10 seconds after switching on the fan heater. When the room
temperature is higher than the set one, and if no selections are made on the control panel within 10 seconds, the fan
heater automatically stops the heating mode and the oscillation (if previously activated), while the ventilation continues for
60 seconds, the settings on the control panel remain unchanged. When the room temperature is 2 ° C lower than the set
one, the fan heater turns on again and resumes the heating mode and oscillation (if previously activated) and shows the
heating power level.
If the Timer and the temperature are set at the same time, the set temperature and time are shown on the display
alternately, with an interval of 30 seconds. If the Timer is not set, only the set temperature appears on the display.
In SET mode, touch the SET button twice to set the Timer: the h LED flashes, then touch the + and - buttons to set the
desired time. The timer can be set from 0 to 12 hours, with an adjustment interval of 1 hour each time the + and - buttons
are pressed.
By holding down the + and - buttons at the same time for over 2 seconds, the time adjustment becomes faster.
If you want to change the previously set Timer, you must reset it by touching the + and – buttons.
On the display, after 5 seconds without any selection on the control panel or by touching any other key except + and -, the
room temperature is shown,
When the Timer reaches 0, the fan heater goes into standby mode.
3. Swing button
Touch this button on the control panel to activate the horizontal swing function of the fan heater. When the function is
activated, the LED
4. ECO button
When the fan heater is on, touch this button on the control panel to select ECO mode, on the control panel, the icon
it turns on. Touch this button again to deactivate this function.
V 05/21
on the control panel is turned off.
on the control panel is turned off.
lights up on the control panel. Touch the swing button again to deactivate this function.
lights up on the display). The transition
20