Argo KASPER 11 Інструкція з експлуатації Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Обігрівач Argo KASPER 11. Argo KASPER 11 10 сторінок. Oil filled radiator
Друкувати сторінку
Choose a suitable place to position the radiator, considering the general safety warnings given in the first part of this
manual. Only use this radiator in an upright position.
Set all controls to OFF position, insert the plug into the electrical socket, ensuring that voltage is compliant with that
specified on the convector data plate.
Rotate the thermostat knob clockwise to MAX (maximum) position and select the desired heat level switching the heater
as follows: I low heat – II medium heat – III high heat
Room temperature can be regulated by rotating the thermostat clockwise to increase or counter clockwise to decrease
temperature.
When the room reaches the desired temperature, slowly rotate the thermostat knob counter clockwise until the power
indicator light goes out, thermostat can be now left at this setting.
When the room temperature has dropped below the set temperature, automatically the radiator will switch itself until the
room temperature will be reached again. In this way the room temperature remains constant with the most economical
use of electricity.
If you want to change the room temperature setting, rotate the thermostat knob clockwise to raise the temperature, of
counter clockwise to lower it.
This heater includes an overheat protection system that shuts off the heater when parts of heater are getting excessively
hot.
Always unplug and leave the radiator to cool before cleaning.
Use a damp cloth to clean the radiator exterior and remove dust. Leave the casing to dry before using the convector
again.
Do not immerse the heater into the water.
Do not allow water to enter the radiator.
Do not use benzene, solvents or abrasive compounds to clean the radiator, as these may damage the casing.
Use a vacuum cleaner to remove dust from the air inlet/outlet grilles.
Ensure that the radiator is dry before inserting the plug.
Do not use metal tools to clean the convector radiator. Any metal fragments that may detach may come into contact
with the panel's electrical components and cause a short-circuit.
In the event of malfunctions or damages, always contact an authorised service centre.
If the radiator is not used for prolonged periods, it must be stored together with this manual in its original packaging, in a
cool and dry place. Never put the appliance away when still hot. Wind the power cord and out it in the special cable box.
Always wait for it to cool down.
V 05/21
HOW TO USE THE RADIATOR
HOW TO CLEAN THE RADIATOR
STORAGE OF RADIATOR
17