Argo PLATINUM 21 Інструкція з експлуатації Посібник з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Осушувач повітря Argo PLATINUM 21. Argo PLATINUM 21 11 сторінок.
Друкувати сторінку
CONTROL PANEL
TANK FULL LED
DEFLECTOR
POSITION LED
FILTER RESET
LED
AIR FLOW
DIRECTION
SETTING
BUTTONS
(1) ON/OFF BUTTON: press to turn the dehumidifier on and off.
(2) FAN BUTTON: press to adjust the fan speed: High, Med, Low.
(3) ON/OFF TIMER BUTTON: the unit can be programmed to switch on (when it is off) and switch off(when it is running)
at increments of 1 hour, from 1 to 24 hours. After setting it, the display will show the time per 5".
(4) HUMIDITY BUTTON: In SMART and QUIET mode, the humidity can be adjusted from 30% to 80% at increments of
10%. After setting it, the display will show the set humidity. The appliance will only start operating if the humidity
level in the room is above the set value.
(5) MODE BUTTON: you can select one of the following dehumidification modes: the corresponding LED will turn on.
Smart: the unit will intelligently select the optimum humidity level based on the current temperature.
Cont (Continuous): the unit will run continuously until the room humidity has reached 50%.
Quiet: the unit will intelligently select the optimum humidity level based on the temperature; the fan is kept to a
minimum to ensure it is as quiet as possible. In this mode, the fan cannot be adjusted.
Dry: special laundry drying feature: the airflow is directed straight up to make it easier to dry the clothes.
(6) WIND DIRECT BUTTON: you can select to make the deflector swing continuously to optimize the airflow around the
room, or decide where to fasten the flap (fixed angle).
LED
FILTER CLEAN LED: THE FILTER CLEAN LED will turn on to indicate that the filter must be cleaned. Take the filter out
and clean it. Then press the FAN and HUMIDITY button at the same time to turn off the Filter Clean LED.
WATER FULL LED: when the tank is full, the WATER FULL LED will come on and the appliance will stop running. A
beep will sound lasting approximately 10 seconds. Remove the tank and empty it (as described in "HOW TO REMOVE
CONDENSATION"), then reposition it correctly; the dehumidifier will start running again.
TANK FULL ALARM: when the internal tank is full, or the tank is not correctly positioned, the unit will sound a beep
lasting approximately 10": then the LED will turn on. Empty the tank or reposition it correctly.
DEFLECTOR POSITION LED: this indicates your selection of a continuous swing or a fixed angle flap position.
DEHUMIDIFICATION MODE LED: this indicates your selected mode.
DISPLAY: this shows the set humidity.
TIMER LED: this indicates the time it is set to on or off.
FAN SPEED LED: this shows the fan speed: HIGH, MID or LOW.
V 10/16
DEHUMIDIFICATION
MODE LED
(6)
(5)
DEHUMIDIFICATION
MODE SELECTION:
- SMART
- CONTINUOUS
- QUIET
- DRY
TIMER LED
DISPLAY
(4)
(3)
HUMIDITY
TIMER
SETTING
HIGH-MEDIUM-LOW
FAN SPEED LED
(2)
(1)
FAN
ON/OFF
BUTTON
18