Sony PlayStation Portable Безпека та підтримка - Сторінка 9

Друкувати сторінку

Sony PlayStation Portable Безпека та підтримка

• Put both the PSP

system and the Remote Control in Hold Mode to

help prevent unintended operation.

Never disassemble the system or

accessories

Use the PSP

system and accessories according to the instructions in this

manual. No authorisation for the analysis or modification of the system,

or the analysis and use of its circuit configurations, is provided.

Disassembling will void the system warranty and may be harmful. The

LCD screen, in particular, contains dangerous, high-voltage parts, and

the laser beam for reading UMD may cause visual impairment if exposed

directly to the eyes.

Using the access point

When using the PSP

system's "Scan" function to select a wireless

LAN access point, access points that are not intended for public use

may be displayed. Only connect to a personal access point that you are

authorised to use, or one that is available through a public wireless

LAN or hotspot service.

Overseas use

When travelling note any applicable wireless regulations.

Moisture condensation

If the PSP

system or UMD is brought directly from a cold location to

a warm one, moisture may condense on the lens inside the system or on

the UMD. Should this occur, the system may not operate properly. In

this case, remove the UMD and turn off and unplug the system. Do not

put the UMD back in until the moisture evaporates (this may take

several hours). If the system still does not operate properly, contact the

appropriate PSP

customer service helpline which can be found within

every PSP

format software manual.

UMD handling

• Do not touch the opening on the rear of the disc (recorded surface of

the disc) with your fingers.

• Do not allow dust, sand, foreign objects or other types of dirt to get

on the disc.

• If the UMD becomes dirty, gently wipe the exterior and recorded

surfaces of the UMD using a soft cloth. Do not use solvents or other

chemicals.

• Do not use a UMD that is cracked or warped or has been repaired.

The UMD may break inside the PSP

malfunction.

Handling and care of exterior surfaces

Follow the guidelines listed below to help avoid deterioration or

discolouration of the PSP

system:

• Do not use solvents or other chemicals to clean the exterior surface.

• Do not allow the system to remain in direct contact with rubber or

vinyl products for an extended period of time.

• Do not use a chemically-treated cleaning cloth to wipe off the

system.

system, leading to injury or

Precautions