Sony SLT-A65M Посібник з експлуатації - Сторінка 9

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Цифрова камера Sony SLT-A65M. Sony SLT-A65M 36 сторінок.

Друкувати сторінку

Ver. 1.6 2013.07

The changed portions from

Ver. 1.5 are shown in blue.

1-7. METHOD FOR REPLACING THE AS HOLDER ACTUATOR ASSY

Removal Procedure

Note: Make sure to perform the removal procedures after removing the

AS Slider B Assy.

(1) Remove the solder on the enamel wires at two places.

Solder

(2) Remove the flexible board from the hook on the AS Holder Actuator

Assy.

Hook

(3) Remove the four screws to remove the AS Holder Actuator Assy.

AS Holder Actuator Assy

1-8. GPS RECEIVING CHECK (SLT-A65V/A65VK/A65VL/A65VM/A65VX/A65VY)

After a part of set was replaced or after the set was assembled, check the reception of GPS signal.

SLT-A65/A65K/A65L/A65M/A65V/A65VK/A65VL/A65VM/A65VX/A65VY/A65X/A65Y_L2

Assembly Procedure

Note: Make sure to perform the assembly procedures before assembling

the AS Slider B Assy.

The assembly procedure is the reverse of the removal procedure.

Apply grease to the portions indicated below.

G G-15 and G G-116

AS Holder Actuator Assy

1-9. NOTE ON REMOVING THE AP IRIS RING

If the AP Iris Ring is removed, the aperture charge cannot be retained. Therefore, after removing the AP Iris Ring, retain the charge in the procedure

below.

(1)

Rotate clockwise the AP Iris Ring as far as it goes.

AP Iris Ring

(2)

Remove the MB H Mount, MB Mount Spacer, and MB Ring SP COM,

unscrewing six screws.

MB H mount

MB Mount Spacer

MB ring SP COM

(3)

Insert the pin (approx. 1mm in diameter) through the hole of front

frame and drop the tip of pin in the cut portion of AP Sensor Gear to

fix the AP Sensor Gear.

Hole of front

frame

Cut portion of

AP Sensor Gear

1-5

– ENGLISH –

(4)

While keeping the pin inserted, remove the Ring Roller B (SV) and

AP Ring Roller C.

Ring Roller B (SV)

AP Ring Roller C

(5)

While keeping the pin inserted, remove the AP Iris Ring.

AP Iris Ring