DIGITEN WTC100 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Терморегулятор DIGITEN WTC100. DIGITEN WTC100 9 сторінок.
Також для DIGITEN WTC100: Посібник користувача (8 сторінок), Посібник користувача (12 сторінок)
cooling operation stops, the relay has no output, the LCD displays
green light on the receiver is off. When the CURRENT value rises to the RUN
value, the cooling operation starts, the LCD displays
the receiver is on.
Heating mode
Set the temperature value RUN<STOP, the controller is in heating mode, and
the LCD displays the HEATING symbol
2.1
When
the
RUN value, the heating operation
displays
, the green light on the receiver is on, when the CURRENT rises
to the STOP value, the heating operation stops, the LCD displays
green light on the receiver is off.
2.2 When the CURRENT temperature value is greater than the STOP value,
the heating operation stops, the LCD displays
receiver is off, when the CURRENT temperature drop to the RUN value, the
heating work starts, the LCD displays
on.
High and low temperature alarm
When the CURRENT temperature is greater than the HIGH value or less than
the LOW value, the remote controller will alarm and the symbol on the LCD will
flash. Press any key to stop the sound, and the symbol continues to flash until
the setting value is changed or CURRENT temperature value returns to the
alarm range.
If the transmitter
to work according to the
minutes.
Delay function
Damage can occur if the compressor restarted too soon after shutdown.
This feature forces the compressor to wait for a few minutes before restarting.
During the
waiting
time has elapsed, the display stop flashing and the compressor turns on
How to set
CURRENT
time, the display will flash
temperature is less than or equal to the
starts, the relay outputs, the LCD
, the green light on the
, the green light on the receiver is
is not powered, the receiver will continue
previous setting value until 5
, When the safe
, the
, the green light on
, the
waiting