Cisco APP-LSS Встановлення та оновлення - Сторінка 18

Переглянути онлайн або завантажити pdf Встановлення та оновлення для Мережеве обладнання Cisco APP-LSS. Cisco APP-LSS 32 сторінки. Fddi card and appliques

Друкувати сторінку

Installing Cards and Appliques

Installing the Applique Card Cage in the Chassis

The applique card cage can only be installed in one of the two large plate areas on the right side of

the rear panel of the chassis. (For the remainder of this procedure, orient the card cage and chassis

as shown in Figure 11.)

Note

area has already been removed.)

Figure 11

Rear of

AGS+ chassis

Step 1

Step 2

Step 3

18 Installing and Upgrading the CSC-C2FCIT FDDI Card and Appliques

If you removed the card cage to install the applique, proceed to step 2. (The connector plate

Installing the FDDI Applique and Card Cage in the AGS+ Chassis

Filler plate

FDDI applique

faceplate

Remove a blank connector plate from one of the two right-side connector areas by

removing the six screws that secure it. (See Figure 11.)

Place the applique card cage inside the rear of the chassis, in the empty large plate area.

(See Figure 11.) Align the screw holes in the rear panel of the chassis with those in the

applique card cage.

Secure the card cage with the connector plate screws you removed earlier, leaving

appropriate holes empty for the ground straps. See Figure 12 and Figure 13 for ground strap

conﬁgurations.

Applique card cage cover

Thumbscrew (4)

FDDI applique

Applique card cage