Sony SEN-231CD Інструкція з експлуатації Посібник з експлуатації - Сторінка 23
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стереосистема Sony SEN-231CD. Sony SEN-231CD 24 сторінки.
Bigelele)(=X-jelereyatare|
Before going through the check list below, first refer back to the connection and operating procedures.
Should any problem persist after you have made these checks, consult your nearest Sony dealer.
Tuner Operation
STEREO indicator blinks.
'
¢ Avery weak FM station or a noisy FM program is received. >
Adjust the antenna or connect an external FM antenna.
Severe hum or noise.
.
© The signal strength is too weak. —> Adjust the antenna, connect an
external antenna or connect the ground wire.
Cassette Deck Operation
The @ button does not activate.
¢ No tape in the cassette compartment.
¢ The tab has been removed from the tape. (See page 11.) -> Cover
the opening with plastic tape.
Function buttons do not activate.
Recording or playback cannot be made, or
there is decrease in sound level.
+
Clean or demagnetize the heads. (See page 21.)
Unbalanced tone in high frequencies..
© Improper setting of the DOLBY NR switch. -> When playing back,
set the switch to the same position used in recording.
© Improper setting of the TAPE SELECTOR switch. (See page 10.) —>
Set correctly.
Compact Disc Operation
The power of the CD player is not turned on.
¢ The function selector is set to the TUNER mode. -> Set to the other
mode.
No sound is heard from one or both channels.
© Incorrect operation of the amplifier.
¢ Loose connection. -» Connect the cords firmly.
Remote commander does not operate the unit.
e No disc tn the disc compartment.
¢ The unit is in the pause mode. -> Press > or tt to release pause.
© Moisture condensation. -> Leave the unit turned on for about an
hour.
¢ The disc is set upside down. —> Set the disc with the label side up.
¢ The disc is tilted. -» Set the disc correctly.
¢ The disc is extremely dirty.
¢ The internal control program may not run. —> Turn off the power and
turn it on again.
Any operation is not possible.
'