Sony SRS-XB30 Кроки з усунення несправностей - Сторінка 3
Переглянути онлайн або завантажити pdf Кроки з усунення несправностей для Стереосистема Sony SRS-XB30. Sony SRS-XB30 4 сторінки. Personal audio system
Також для Sony SRS-XB30: Довідковий посібник (2 сторінок), Довідковий посібник (2 сторінок), Довідковий посібник (2 сторінок), Довідковий посібник (2 сторінок), Довідковий посібник (2 сторінок)
Друкувати сторінку
If the
(BLUETOOTH) indicator is not flashing quickly in white, press and hold the
PAIRING button until you hear beeps and the
quickly in white.
Connect the speaker to an AC outlet or charge the battery of the speaker sufficiently.
Once the speaker is initialized, an iPhone/iPad/iPod touch may not be able to connect to the
speaker. In this case, delete pairing information on the iPhone/iPad/iPod touch then pair them
again.
7) Unable to connect the speaker to a BLUETOOTH device with One-touch connection (NFC)
Keep the NFC-compatible device close to the speaker until the device reacts. If you fail to
connect, move the device slowly over the N marked part of the speaker.
Check that the NFC function of the device is set to on.
If the device is attached with a case, remove it.
NFC reception sensitivity varies depending on the device. If you repeatedly fail to connect the
speaker with a device by one touch, connect/disconnect it to the speaker by on-screen
operation.
Check that your device is compatible with NFC. Look up information on the issue on the
customer support website.
To use the Speaker Add function or Wireless Party Chain function, pair with the speaker where
the
(BLUETOOTH) indicator flashes in white.
8) Unable to connect a BLUETOOTH device with the speaker in the Speaker Add function
After connecting two SRS-XB30 speakers, perform the pairing procedure between a BLUETOOTH
device and the speaker where the
BLUETOOTH connection.
9) Unable to connect with a speaker in the Wireless Party Chain function
After connecting two speakers, perform the pairing procedure between a BLUETOOTH device
and the speaker where the
BLUETOOTH connection.
10) Using the RESET button
If the speaker cannot be turned on or cannot be operated despite it being turned on, open the cap on
the rear side and push the RESET button with a pin or other pointed objects. The speaker is reset and
turns off.
(BLUETOOTH) indicator is flashing in white. Then, make a
(BLUETOOTH) indicator is flashing in white. Then, make a
(BLUETOOTH) indicator begins to flash
(power)