Sony SS-XGR600 Інструкція з експлуатації Посібник з експлуатації - Сторінка 12
Переглянути онлайн або завантажити pdf Інструкція з експлуатації Посібник з експлуатації для Стереосистема Sony SS-XGR600. Sony SS-XGR600 36 сторінок. Sony component hi-fi stereo system operating instructions lbt-xgr88/xgr66 lbt-xgr600
Друкувати сторінку
To improve tuner reception
When tuner reception is poor, set CD player
power off by CD power manage function.
CD power is factory set to on.
1
Press FUNCTION repeatedly until "CD"
appears.
2
Press ?/1 to turn off the system.
3
Press ?/1 while holding x.
"CD POWER OFF" appears.
To set CD power on
Repeat the procedure above and "CD POWER
ON" appears.
Notes
• When "CD POWER OFF" is selected, CD access
time is increased.
• You cannot change the setting in Power Saving
Mode (page 21).
To change the AM tuning interval
The AM tuning interval is factory-preset to
9 kHz (or 10 kHz for some areas). To change the
AM tuning interval, tune in any AM station first,
then turn off the system. While holding TUNER
ENTER, press ?/1 to turn the system back on.
When you change the interval, all the AM preset
stations are erased. To reset the interval, repeat
the same procedure.
Note
You cannot change the AM tuning interval in the
Power Saving Mode (page 21).
Tips
• The preset stations are retained for half a day even if
you disconnect the power cord or if a power failure
occurs.
• To improve the reception, adjust the supplied
antennas or connect an external antenna.
GB
12
Listening to the radio
You can listen to a radio station either by
selecting a preset station, or by manually tuning
in the station.
Listening to a preset station
— Preset Tuning
Preset radio stations in the tuner's memory first
(see "Presetting radio stations" on page 11).
1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press TUNING MODE repeatedly until
"PRESET" appears.
3
Press TUNING +/– (or PRESET +/– on
the remote) repeatedly to select the
desired preset station.
Listening to non-preset radio
station
— Manual Tuning
1
Press TUNER/BAND repeatedly to
select "FM" or "AM".
2
Press TUNING MODE repeatedly until
"MANUAL" appears.
3
Press TUNING +/– repeatedly to tune in
the desired station.
Tips
• To improve broadcast reception, adjust the supplied
antennas, or connect a commercially available
external antenna.
• When an FM stereo program has static noise, press
FM MODE repeatedly until "MONO" appears.
There will be no stereo effect, but the reception will
improve.
• Press TUNING MODE repeatedly until "AUTO"
appears in step 2 above, then press TUNING +/–.
The frequency indication changes and scanning stops
when the system tunes in a station (Automatic
Tuning).
• To record the radio programs, use manual recording
(page 15).