Cisco ASA 5585-X Посібник з технічного обслуговування - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник з технічного обслуговування для Мережеве обладнання Cisco ASA 5585-X. Cisco ASA 5585-X 44 сторінки. Maintenance and upgrade procedures
Також для Cisco ASA 5585-X: Посібник із швидкого старту (40 сторінок), Посібник із швидкого старту (6 сторінок)
Друкувати сторінку
Chapter 4
Maintenance and Upgrade Procedures
Install the new power supply module by aligning it with the power supply module bay and pushing it
Step 5
into place until it is seated
Figure 4-13
2
1
Power supply module and power
supply module handle
Tighten the captive screws.
Step 6
Reconnect the power cable. If you are installing two power supply modules for a redundant configuration
Step 7
(Figure
Figure 4-14
1
Power supply module (PS0)
If you had to power off the security appliance because you are removing and replacing the only power
Step 8
supply module, power it back on.
Check the PS0 and PS1 indicators on the front panel to make sure they are green. On the back panel of
Step 9
the security appliance, make sure the IN OK and the FAN OK indicators are green and the OUT FAIL
indicator is off (see
OL-22567-02
(Figure
Installing the AC Power Supply Module
Ci sc o AS
10 0-2 40
V
15 .0/ 8.0
.A
56 /60 Hz
IN PU T
1
4-14), plug each one into a power source—we recommend a UPS.
PS0 and PS1
1
Figure
4-11and
Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide
Removing and Installing the Power Supply Module
4-13).
A 12 00 W
AC
FA N
OU TP UT
2
2
Power supply module screws
Cisco ASA 1200W AC
100-240V
15.0/8.0.A
56/60Hz
2
Power supply module (PS1)
Table
4-3).
C is co -A
S A -F A
Ci sc o AS
N
A 12 00 W
AC
10 0-2 40
V
15 .0/ 8.0
.A
56 /60 Hz
2
Cisco ASA 1200W AC
100-240V
15.0/8.0.A
56/60Hz
4-15