Cisco ASR 9000 Series Посібник - Сторінка 27

Переглянути онлайн або завантажити pdf Посібник для Мережеве обладнання Cisco ASR 9000 Series. Cisco ASR 9000 Series 44 сторінки. Line card
Також для Cisco ASR 9000 Series: Налаштування мережевих параметрів (26 сторінок), Посібник з конфігурації (46 сторінок), Посібник з конфігурації (50 сторінок), Посібник (24 сторінок), Налаштування (46 сторінок), Короткий довідник (7 сторінок)

Replacing Cisco ASR 9000 Series Router Components

Caution

Replacing Cards in the Chassis

Follow these steps to replace a previously removed RSP card, RP card, FC, or LC from the card cage:

Procedure

Step 1

Install the card:

a) Slide the card into the slot, being sure to install the card in the same slot you recorded when you removed

the card.

b) Use the 6-inch long number 2 Phillips screwdriver to a torque of 10 +/–1 in-lb to tighten the captive screws

at each end of the card front panel.

c) Pivot the ejector levers to seat the card into the backplane connector.

Step 2

Reconnect cables to the card:

a) If you previously disconnected the card cable management bracket, reattach it to the card and use the

6-inch long number 2 Phillips screwdriver to a torque of 10 +/–1 in-lb to tighten the captive screw on the

bracket to secure it to the card front panel.

b) Carefully reroute the cables through the horizontal cable management tray at the top of the chassis (the

Cisco ASR 9922 Router has an additional tray at the bottom of the chassis) or side cable management

brackets (Cisco ASR 9006 Router and Cisco ASR 9904 Router).

c) Carefully reroute cables through the card cable-management bracket.

d) Starting with the port of the card closest to the cable management bracket, reconnect the interface cable

connectors to each of the card ports using the cable and port connection information you recorded when

removing the cables.

Step 3

If the card was powered down using CLI before removal, then power up the card using the CLI:

Router# admin

Router(admin)# config

Router(admin-config)# no hw-module power disable location location

Router(admin-config)# commit

Router(admin-config)# exit

The location is specified in rack/slot/cpu notation. For example, no hw-module power disable location

0/1/CPU0.

Migrating from RP1 to RP2 Card

Before you begin:

• You must have console access to the router.

A line card surface temperature may exceed 55 °C during normal operation. To avoid burn

injuries, please take necessary precautions while removing the heated card from the chassis.

Replacing Cisco ASR 9000 Series Router Components

Replacing Cards in the Chassis