Cisco ATM Cable Interface Processor ACIP-SM(=) Посібник з встановлення та налаштування - Сторінка 24
Переглянути онлайн або завантажити pdf Посібник з встановлення та налаштування для Мережеве обладнання Cisco ATM Cable Interface Processor ACIP-SM(=). Cisco ATM Cable Interface Processor ACIP-SM(=) 33 сторінки. Atm cable interface processor (acip)
Друкувати сторінку
Configuring the ACIP
To create a bridge-group virtual interface, perform the following tasks in interface configuration
mode:
Task
Step 1
Step 2
Step 3
Step 4
Note
Transparent Bridging" chapter of the Bridging and IBM Network Configuration Guide.
Configure Protocols for Routing or Bridging
When integrated routing and bridging is enabled, the default route/bridge behavior in a bridge group
is to bridge all packets.
You can then explicitly configure the bridge group to route a particular protocol, so that routable
packets of this protocol are routed, while non-routable packets of this protocol or packets for
protocols for which the bridge group is not explicitly configured to route will be bridged.
To configure specific protocols to be routed in a bridge group, perform the following task in global
configuration mode:
Task
Specify the IP protocol to be routed in a bridge group.
When you intend to bridge and route a given protocol in the same bridge group, you must configure
the network-layer attributes of the protocol on the bridge-group virtual interface. Do not configure
protocol attributes on the bridged interfaces. No bridging attributes can be configured on the
bridge-group virtual interface.
Although it is generally the case that all bridged segments belonging to a bridge group are
represented as a single segment or network to the routing protocol, there are situations where several
individual networks coexist within the same bridged segment. To make it possible for the routed
domain to learn about the other networks behind the bridge-group virtual interface, configure a
secondary address on the bridge-group virtual interface to add the corresponding network to the
routing process.
Note
"Configuring Transparent Bridging" chapter of the Bridging and IBM Network Configuration
Guide.
24 ATM Cable Interface Processor (ACIP) Installation and Configuration
Enable a bridge-group virtual interface.
Specify the IP address for the interface.
Disable the sending of redirect messages.
Optionally, enable fast-switching on the
interface.
For more information on bridge-group virtual interfaces, refer to the "Configuring
For more information on the protocols to be routed in a bridge group, refer to the
Command
interface bvi bridge-group
ip address ip-address mask
no ip redirects
ip route-cache same-interface
Command
bridge bridge-group route ip