Argo S6999 Посібник з експлуатації - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Позашляховик Argo S6999. Argo S6999 16 сторінок. Ducting & exhaust

Ducting & Exhaust

Assembling and Installing the Muffler Assembly (Conquest Models)

On an uncluttered work surface, orient the muffler heat shield assembly with the

rubber shock lower support, to the back. Insert the muffler into the shroud with the

exhaust inlet situated to the right. Photo DE-15

Turning the tailpipe end of the shroud around to face the assembler will put the

tailpipe also to the right side of the shroud. Photo DE-16

Reinstall the 2 lower fasteners to secure the muffler at the bottom of the shroud.

Photo DE-17

Flip the assembly over and secure the muffler at the exhaust inlet end.

Photo DE-18

Secure the heat shield with the appropriate hardware. Refer to your illustrated parts

manual for correct hardware and orientation. Photo DE-19

Install the assembly into the vehicle at 90 degrees, compressing the rubber mounted

lower support to ease the installation and provide enough clearance in the engine

compartment. Photo DE-20 Set the assembly on to the front wheel well temporarily

Ontario Drive & Gear Limited

PH.(519)- 662-2840 FAX (519)- 662-2421

DE-15

DE-17

DE-6

Argo Service Manual

DE-16

DE-18