DIGITIZE System 3505 Посібник з експлуатації - Сторінка 4

Переглянути онлайн або завантажити pdf Посібник з експлуатації для Сервер DIGITIZE System 3505. DIGITIZE System 3505 12 сторінок. Remote alarm terminal option
Також для DIGITIZE System 3505: Посібник з монтажу та експлуатації (20 сторінок)

Друкувати сторінку

Engine OK, Engine Repeat are features assigned to Custom Program #0101 only. Please advise

your sales representative if you wish to include this or other features in your system.

Test Mode

1. Any circuit can be placed in test mode by activating two taps prior to pulling the

box to be tested. The SYSTEM 3505 will substitute the word 'TEST' for 'BOX'

when decoding a box on a circuit placed in a test mode. You must wait at least 5

seconds from the time you release the key on the second tap, until you pull the

box to be tested. Caution should be used to verify that a 'real' box does not come

in while you are in the test mode, waiting for the test box to be pulled. It is

recommended that you either communicate with the field personnel ad be advised

what box is to be pulled, or make it the responsibility of the field tech to notify

fire dispatch should he "hear" another box activation while waiting to pull the test

box.

2. Once a box is placed in the test mode, a timer is displayed on the right end of the

circuit line. This timer counts down from 180 seconds. Once the test box is

pulled, the circuit shall remain in the test mode until 180 seconds lapses, or four

rounds are decoded with the last two boxes matching. Once this happens, and the

decoding ends, the test count will automatically go to zero, concluding the test

mode.

3. The test mode will also automatically end if there is no new activity on the circuit

for thirty seconds.

4. To start the cycle over again, the field personnel must tap two on the circuit again.

5. The test mode can be ended at any time by a single tap on the circuit already in

the test mode.

Roll key

1. You can only ROLL a box if there is a minimum of two circuits being displayed.

2. The ROLL key allows you to take whatever telegraph box is on the top line

(printing line) and ROLL it to the bottom of the stack. This will cause the next

box in line, to now be the top box on the display, thus printing its box rounds.

The third box will be the second and so on.

3. Once a Rolled box makes its way back to the top line, the word "Rolled" will be

printed on the thermal paper to indicate that this box has previously at least

printed some of the rounds.

SST Transmit

1. Any Remote Alarm Terminal may initiate a box transmission. The process is as

follows:

a. Enter desired Box number to be transmitted. For a box containing ten

blows as the first digit, enter a "0", then the rest of the box. For example

box 10-123 would be entered as 0123. Alternatively for a ten, you can

enter the box as 10-123. A delay that is longer then an inter digit, but

shorter then an end of round will occur between the ten and the rest of the

box number in either of the two methods indicated.

Specifications Subject to Change Without Notice

DIGITIZE, INC. 700251 REV B 04/02