Cisco Catalyst 3750-E Series Посібник для початківців - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник для початківців для Мережеве обладнання Cisco Catalyst 3750-E Series. Cisco Catalyst 3750-E Series 33 сторінки. Switches and power supply modules
Також для Cisco Catalyst 3750-E Series: Бюлетень підтримки продукту (6 сторінок), Бюлетень підтримки продукту (5 сторінок), Бюлетень підтримки продукту (6 сторінок), Вказівки щодо встановлення (20 сторінок), Посібник для початківців (27 сторінок)

The Express Setup Basic Settings page appears. If it does not appear, see the "In Case of

Step 11

Difficulty" section on page 22.

Enter this information in the Network Settings fields:

Step 12

• In the Management Interface (VLAN ID) field, the default is 1. Enter a new VLAN ID

only if you want to change the management interface through which you manage the

switch. The VLAN ID range is 1 to 1001.

• In the IP Address field, enter the IP address of the switch. In the IP Subnet Mask field,

click the drop-down arrow, and select an IP Subnet Mask.

• In the Default Gateway field, enter the IP address for the default gateway (router).

• Enter your password in the Switch Password field. The password can be from 1 to 25

alphanumeric characters, can start with a number, is case sensitive, allows embedded

spaces, but does not allow spaces at the beginning or end. In the Confirm Switch

Password field, enter your password again.

Step 13

(Optional) Enter this information in the Ethernet Management Port Settings fields:

• In the IP Address field, enter the IP address of the Ethernet management port. In the

IP Subnet Mask field, click the drop-down arrow, and select an IP Subnet Mask.

Step 14

(Optional) You can enter the Optional Settings information now or enter it later by using

the device manager interface:

• In the Host Name field, enter a name for the switch. The host name is limited to 31

characters; embedded spaces are not allowed.

• Enter the date, time, and time zone information in the System Date, System Time, and

Time Zone fields. Click Enable to enable daylight saving time.