Cisco Catalyst 8300 Series Посібник з встановлення обладнання - Сторінка 34

Переглянути онлайн або завантажити pdf Посібник з встановлення обладнання для Мережеве обладнання Cisco Catalyst 8300 Series. Cisco Catalyst 8300 Series 46 сторінок. Edge ucpe

Друкувати сторінку

Installing a Dual In-line Memory Module (DIMM)

5. Lift the chassis cover after you have removed all the screws.

Note

•

Installing a Dual In-line Memory Module (DIMM)

There are four DDR4 DIMM slots. DIMMs have a polarization notch on the connecting edge to prevent

incorrect orientation of the module during insertion.

Figure 1. DIMM Showing Polarization Notch

These are the steps to install a DIMM:

1. Remove the chassis cover.

2. Locate the DIMM slots on the device. There are four DIMM slots in the chassis and you can install the

DIMM module on any of the slots.

3. Make sure that both latches on the DIMM connector are in the open position.

Figure 2. DIMM orientation

Cisco Catalyst 8300 Series Edge uCPE Hardware Installation Guide

To replace the chassis cover, place the cover evenly on the top of the device and use the screws to secure it

to the device.

Installing a Dual In-line Memory Module (DIMM), on page 30

Removing a DIMM, on page 31

Installing the M.2 Storage Module, on page 31

Installing and Removing a Network Interface Module (NIM), on page 33

Installing Pluggable Interface Module, on page 34

Installing Drive Bays, on page 35

Replace (Remove and Install) Fan Tray, on page 37

Remove Small Form Pluggable Modules, on page 38

Install and Upgrade Field Replaceable Units

Polarization Notch