Cisco Cisco ASA Series Початок роботи - Сторінка 26

Переглянути онлайн або завантажити pdf Початок роботи для Мережеве обладнання Cisco Cisco ASA Series. Cisco Cisco ASA Series 31 сторінка.
Також для Cisco Cisco ASA Series: Встановлення та підключення (12 сторінок), Встановлення та підключення (6 сторінок)

Copy the Startup Configuration to the Running Configuration

• For contexts that are not saved because of bad sectors in the flash memory, the following message

Copy the Startup Configuration to the Running Configuration

Use one of the following commands to copy a new startup configuration to the running configuration:

• copy startup-config running-config

• reload

• clear configure all and then copy startup-config running-config

The following commands let you view the running and startup configurations:

• show running-config

• show running-config command

• show startup-config

To erase settings, enter one of the following commands:

• clear configure configurationcommand [level2configurationcommand]

CLI Book 1: Cisco ASA Series General Operations CLI Configuration Guide, 9.5

context 'a' , context 'b' , context 'c' .

appears:

The context 'context a' could not be saved due to Unknown errors

Merges the startup configuration with the running configuration. A merge adds any new commands

from the new configuration to the running configuration. If the configurations are the same, no changes

occur. If commands conflict or if commands affect the running of the context, then the effect of the

merge depends on the command. You might get errors, or you might have unexpected results.

Reloads the ASA, which loads the startup configuration and discards the running configuration.

Loads the startup configuration and discards the running configuration without requiring a reload.

Views the running configuration.

Views the running configuration of a specific command.

Views the startup configuration.

Clears all the configuration for a specified command. If you only want to clear the configuration for a

specific version of the command, you can enter a value for level2configurationcommand.

Getting Started