Cisco Cisco MDS 9216A - Fabric Switch Примітка до випуску - Сторінка 8

Переглянути онлайн або завантажити pdf Примітка до випуску для Мережеве обладнання Cisco Cisco MDS 9216A - Fabric Switch. Cisco Cisco MDS 9216A - Fabric Switch 22 сторінки. Multilayer fabric switch
Також для Cisco Cisco MDS 9216A - Fabric Switch: Посібник з конфігурації (49 сторінок), Примітка до випуску (48 сторінок), Примітка до випуску (44 сторінок), Примітка до випуску (44 сторінок), Примітка до випуску (36 сторінок), Примітка до випуску (26 сторінок), Короткий довідник (14 сторінок), Примітка до випуску (3 сторінок), Специфікація (15 сторінок)

SERIAL PORT

You must use the serial interface to configure a switch IP address. Refer to the Cisco MDS 9000

Family Configuration Guide or Cisco MDS 9020 Fabric Switch Configuration Guide for

instructions on how to connect the serial port to a host machine.

INITIAL INSTALLATION RECOMMENDATIONS /

REQUIREMENTS

The C-series MDS 9000 Family of switches does not automatically allow SAN connectivity for

the first-time, out-of-the box power up. For more comprehensive initial setup information,

please refer to the Cisco documentation found at http://www.cisco.com.

Note:

The setup dialog prompts for all of the necessary settings.

The following steps must be taken during the first-time setup:

I. To enable all ports on the switch, set the ports to noshut – by default, all switch ports are set

to shut

During the setup command:

Configure default switchport interface state (shut/noshut) [shut]: noshut

II. To allow traffic flow to all members of a default zone, set the default zone to permit

connectivity – by default, zoning is set to deny

During the setup command:

Configure default zone policy (permit/deny) [deny]: permit

III. If upgrading from SAN-OS 1.3(4a) or earlier, enable FCID persistence for all VSANs on

the switch – FCID persistence is enabled by default with SAN-OS 2.0(1b) and newer.

Note: FCID persistence is not supported on the MDS 9020.

Enable persistent FCID for each VSAN using the CLI dialog as follows:

switch# config terminal

switch(config)# fcdomain fcid persistent vsan 1

switch(config)# exit

switch# copy running-config startup-config

In this example, the number 1 at the end of the line is the name of the default VSAN ID. If

additional VSANs were created, you must repeat this command for each additional VSAN.

For example, if you added two more VSANs with ID numbers 2 and 3, you must enter the

following commands:

switch# config terminal

switch(config)# fcdomain fcid persistent vsan 2

switch(config)# fcdomain fcid persistent vsan 3

switch(config)# exit

switch# copy running-config startup-config

MDS Multilayer Director & Multilayer Fabric Switches Release Notes