Cisco Content Engine 565 Посібник з монтажу - Сторінка 22

Переглянути онлайн або завантажити pdf Посібник з монтажу для Мережеве обладнання Cisco Content Engine 565. Cisco Content Engine 565 28 сторінок. Content engine

Друкувати сторінку
Cisco Content Engine 565 Посібник з монтажу

Accessing the ACNS Software on the Content Engine

Table 4
LED
Green
Amber
Green
Amber
Green
Amber
Green
Amber
Green
Amber
Accessing the ACNS Software on the Content Engine
The Content Engine uses the Cisco Application and Content Networking System (ACNS) software for
configuration and deployment of an Application and Content Network (ACN). The ACNS software
includes both a graphical user interface, accessible through a web browser, and a command-line interface
(CLI), either of which can be used to configure the software. For more information about accessing and
configuring the ACNS software, refer to the Cisco ACNS Software Deployment and Configuration Guide
that is appropriate for the version of ACNS software running on your Content Engine.
To use the ACNS software CLI, you must connect to the Content Engine either through a Telnet session
from a PC, or by connecting a PC or terminal to the Content Engine console port.
Connecting a PC to the Content Engine
To access the ACNS software on the Content Engine through the console port on the Content Engine,
you must connect the Content Engine to a terminal or PC. The console cable and adapter required for
this connection are included with the Content Engine.
To connect to the Content Engine using a PC, the PC must have some type of terminal emulation
software installed. The terminal emulation software should be configured with the following parameters:
•
•
•
•
Installing the Cisco Content Engine 510 and 565
22
Fibre Channel Card LEDs
State
On
On
On
Off
Off
On
Off
Flashing
Flashing
Flashing
9600 baud
8 data bits
No parity bits
1 stop bit
Meaning
Power is on.
Fibre Channel is on line.
Signal acquired (the Fibre Channel card firmware is
performing or waiting to perform Fibre Channel
loop initialization).
Loss of synchronization.
Firmware error.
78-14731-02