Cisco Firepower 4150 Посібник - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник для Мережеве обладнання Cisco Firepower 4150. Cisco Firepower 4150 36 сторінок. Rack-mount and ground the chassis
Також для Cisco Firepower 4150: Посібник з технічного обслуговування та модернізації (20 сторінок), Посібник (26 сторінок), Посібник (8 сторінок), Посібник (42 сторінок), Початок роботи (42 сторінок)

Hardware Bypass Network Modules

Note

Hardware bypass is only supported in inline mode. Also, hardware bypass support depends on your software

application.

Note

When the appliance switches from normal operation to hardware bypass or from hardware bypass back to

normal operation, traffic may be interrupted for several seconds. A number of factors can affect the length of

the interruption; for example, behavior of the optical link partner such as how it handles link faults and

debounce timing; spanning tree protocol convergence; dynamic routing protocol convergence; and so on.

During this time, you may experience dropped connections.

There are three configuration options for hardware bypass network modules:

• Passive interfaces—Connection to a single port.

For each network segment you want to monitor passively, connect the cables to one interface. This is

how the nonhardware bypass network modules operate.

• Inline interfaces—Connection to any two like ports (10 Gb to 10 Gb for example) on one network module,

across network modules, or fixed ports.

For each network segment you want to monitor inline, connect the cables to pairs of interfaces.

• Inline with hardware bypass interfaces—Connection of a hardware bypass paired set.

For each network segment that you want to configure inline with fail-open, connect the cables to the

paired interface set.

For the 40-Gb network module, you connect the two ports to form a paired set. For the 1/10-Gb network

modules, you connect the top port to the bottom port to form a hardware bypass paired set. This allows

traffic to flow even if the security appliance fails or loses power.

Note

If you have an inline interface set with a mix of hardware bypass and nonhardware bypass interfaces, you

cannot enable hardware bypass on this inline interface set. You can only enable hardware bypass on an inline

interface set if all the pairs in the inline set are valid hardware bypass pairs.

For More Information

• See

Overview

1-Gb Network Module with Hardware Bypass, on page 13

module.

40-Gb Network Module with Hardware Bypass, on page 14

network module.

1-Gb SX/10-Gb SR/10-Gb LR Network Module with Hardware Bypass, on page 15

description of the 1-Gb SX, 10-Gb SR and LR network modules.

Install the Network Module

modules.

for the procedure for removing and replacing single-wide network

Overview

for a description of the 1-Gb network

for a description of the 40-Gb

for a