Cisco Firepower 4150 Посібник - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник для Мережеве обладнання Cisco Firepower 4150. Cisco Firepower 4150 36 сторінок. Rack-mount and ground the chassis
Також для Cisco Firepower 4150: Посібник з технічного обслуговування та модернізації (20 сторінок), Посібник (26 сторінок), Посібник (8 сторінок), Посібник (42 сторінок), Початок роботи (42 сторінок)
Друкувати сторінку
Overview
3
5
The following table describes the cable specifications needed to keep the insertion loss as low as possible.
Table 2: 40-Gb BASE-SR Cable Specifications
Interface
Ethernet 40-G BASE-SR4
850 nm wavelength
MPO-12 port adapter
Note
See the
We recommend the following Cisco OM3 MTP/MPO cables.
Table 3: Cisco Cables
Cisco Part Number
CAB-ETH-40G-5M
CAB-ETH-40G-10M
CAB-ETH-40G-20M
1-Gb SX/10-Gb SR/10-Gb LR Network Module with Hardware Bypass
The following figure shows the front panel of the 1-Gb SX, 10-Gb SR and 10-Gb LR hardware bypass network
modules (FPR4K-NM-6X1SX-F, FPR4K-NM-6X10SR-F, FPR4K-NM-6X10LR-F). This is a single-wide
module that does not support hot swapping. The six ports are numbered from top to bottom, left to right. Pair
ports 1 and 2, 3 and 4, and 5 and 6 to form hardware bypass paired sets.
Bypass LED BP:
• Green—In standby mode.
• Amber, flashing—Port is in hardware bypass
mode, failure event.
• Amber—Port is in hardware bypass mode,
forced.
Network activity LEDs for Pair 1:
• Amber—No connection, or port is not in
use, or no link or network failure.
• Green—Link up, no network activity.
• Green, flashing—Network activity.
Cisco 40GBASE QSFP Modules Data Sheet
1-Gb SX/10-Gb SR/10-Gb LR Network Module with Hardware Bypass
4
Ethernet X/2
Ports 1 and 2 are paired together to form a
hardware bypass pair.
Network activity LEDs for Pair 2:
6
• Amber—No connection, or port is not in use,
or no link or network failure.
• Green—Link up, no network activity.
• Green, flashing—Network activity.
Supported Cable
50 microns core diameter
2000/4700 (OM3/4) modal bandwidth (MHz*km)
50 m cable distance
for specifications of the QSFP for the 40-Gb BASE-SR-4.
Cable Length
5 m
10 m
20 m
Overview
15