Cisco Firepower 4150 Посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник для Мережеве обладнання Cisco Firepower 4150. Cisco Firepower 4150 8 сторінок. Rack-mount and ground the chassis
Також для Cisco Firepower 4150: Посібник з технічного обслуговування та модернізації (20 сторінок), Посібник (36 сторінок), Посібник (26 сторінок), Посібник (42 сторінок), Початок роботи (42 сторінок)

Rack-Mount and Ground the Chassis

You need the following items that you provide:

• Wire-striping tool

• Crimping tool

• Grounding cable

• Two star lock washers for the 10-32 x 0.375-inch screws used to secure the ground lug

• You need the following items from the accessory kit:

Safety Warnings

Warning

Step 1

Use a wire-stripping tool to remove approximately 0.75 inches (19 mm) of the covering from the end of the grounding

cable.

Step 2

Insert the stripped end of the grounding cable into the open end of the grounding lug.

Figure 5: Insert the Cable into the Grounding Lug

• Grounding lug #6 AWG, 90 degree, #10 post

• Two 10-32 x 0.375-inch screws used to secure the grounding lug

Take note of the following ground connection warnings:

Statement 1024 Ground Conductor

This equipment must be grounded. To reduce the risk of electric shock, never defeat the ground conductor

or operate the equipment in the absence of a suitably installed ground conductor. Contact the appropriate

electrical inspection authority or an electrician if you are uncertain that suitable grounding is available.

Statement 1025 Use Copper Conductors Only

To reduce risk of fire, use copper conductors only.

Statement 1052 Installing and Grounding the Antenna

To reduce the risk of electric shock, refer to national and local codes for proper installation and grounding

of antennas.

Ground the Chassis

Rack-Mount and Ground the Chassis