Cisco Firepower 9300 Встановлення та обслуговування - Сторінка 35

Переглянути онлайн або завантажити pdf Встановлення та обслуговування для Мережеве обладнання Cisco Firepower 9300. Cisco Firepower 9300 36 сторінок. Installation, maintenance, and upgrade guide
Також для Cisco Firepower 9300: Початок роботи (42 сторінок)

Друкувати сторінку

Installation, Maintenance, and Upgrade

Figure 15: Run the Cables Through the FIPS Opacity Shield

Cable exit

Step 6

Attach the TELs. For information on the procedure and correct placement of the TELs, see the Tamper Evidence Label

(TEL) Placement section in the

Step 7

Connect the power cords to the chassis, and plug the other end into your power source. The chassis has a power switch

on the rear. Toggle it to the ON position.

Note

The initial AC-power chassis does not have an on/off switch; it powers on when you plug it into a power source.

When you toggle the power switch from ON to OFF, it takes several seconds for the system to power down.

Note

Do not remove the power cable until the power LED is off. After removing power from the chassis either by

moving the power switch to OFF or unplugging the power cord, wait at least 10 seconds before turning power

back ON.

Step 8

Check the SYS LED on the front of the chassis. See

When the SYS LED is solid green, the chassis has booted up successfully.

Step 9

See the

Cisco Firepower 9300 Getting Started Guide

FIPS 140-2 Non Proprietary Security Policy Level 2 Validation

Supervisor

for further configuration information.

Install the FIPS Opacity Shield

for a description of the SYS LED.

Installation, Maintenance, and Upgrade

document.