Cisco Firepower 9300 Встановлення та обслуговування - Сторінка 8
Переглянути онлайн або завантажити pdf Встановлення та обслуговування для Мережеве обладнання Cisco Firepower 9300. Cisco Firepower 9300 36 сторінок. Installation, maintenance, and upgrade guide
Також для Cisco Firepower 9300: Початок роботи (42 сторінок)
Друкувати сторінкуInstall, Remove, and Replace the Single-Wide Network Module
Figure 3: Remove the SSD
1
Handle
Step 3
To replace the SSD, hold the SSD in front of slot 1, push it in gently until it is seated, and close the handle.
Step 4
Tighten the captive screws on either side of the SSD.
Step 5
Acknowledge the slot to start the SSD installation.
Install, Remove, and Replace the Single-Wide Network Module
This procedure describes how to install a network module into an empty slot that has never contained a network
module, and how to remove an installed network module and replace it with another network module.
Hot Swapping
Caution
Installation, Maintenance, and Upgrade
8
Verify that you have the correct software to support hot swapping on the Firepower 10-Gb and 40-Gb
nonhardware bypass network modules. See
software compatibility matrix. You must hot swap with an identical network module, that is, a network
module with the same PID. See
bring the network module offline using the appropriate CLI commands before removing the network
module from the chassis so that all network module configuration is saved.
We do not recommend that you remove the network module without bringing it properly offline
using the appropriate CLI commands.
2
Handle release
Cisco Firepower 4100/9300 FXOS Compatibility
Product ID Numbers
for a list of the network module PIDs. You must
Installation, Maintenance, and Upgrade
for the