Digitrax DH166PS Посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник для Конвертер мультимедіа Digitrax DH166PS. Digitrax DH166PS 8 сторінок. Mobile decoder

Друкувати сторінку

Parts List

1 DH166PS Function Decoder

1 Instruction Sheet

DHWHPS Digitrax Easy Connect 9 Pin to DCC Medium Plug 1.0" harness

Installation Information

See the Digitrax Decoder Manual for complete decoder test procedures, instal-

lation instructions, programming and technical information. Digitrax manuals

and instructions are updated periodically. Please visit www.digitrax.com for the

latest versions, technical updates and additional locomotive-specific installation

instructions. CAUTION: Programming and layout track must not exceed

16V when using this decoder.

Installation Instructions

Carefully remove the locomotive shell.

(Figure 1) Note the orientation to

the frame for correct re-installation.

Remove the jumper plug/s from

the locomotive's DCC ready socket.

(Figure 2) The jumper plugs allow

the loco to operate on a standard DC

track or in analog mode on a DCC

track.

Insert the DCC plug end of the

harness into the socket. The pin with

the orange wire plugs into the hole

marked 1. (Figure 3) Seat the decod-

er firmly in the socket.

Plug the 9 pin connector end of the

harness into the DH166PS Decoder.

The plug is notched for proper orien-

tation of plug and socket.

Outputs for F1 (Green) and F2

(Violet) can be wired to additional

functions if desired.

Replace the loco shell on the frame.

The loco is now ready to run on your

DCC system using the factory set

address 03. See next page for cus-

tomizing some of the functions of the

DH166PS decoder.

Figure 1: Remove loco shell

Figure 2: Carefully

remove jumper plug(s)

DCC medium

plug

Figure 3:

Carefully plug in decoder

— 2 —

Jumper plug

F1 (Green)

F2 (Violet)

9 pin

connector

Decoder