Digitrax DN143IP Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Контролер Digitrax DN143IP. Digitrax DN143IP 8 сторінок. Complete train control

Function Outputs on the DN143IP

The DN143IP is set up at the factory to control four function outputs. The

DN143IP is configured to control the forward and reverse lights on the locomo-

tive through the plug using Function 0 (F0F-forward and F0R-reverse) for

directional lighting. Function F1(Green) and F2 (Violet) outputs are available

in the pad positions shown in figure 1. The wire colors indicated are the stan-

dard color code used in the industry. These colors are important if you plan to

use function remapping.

All four function outputs can be easily set up with Digitrax FX

or as standard on/off functions with the following operational qualifiers:

1. Forward or Reverse direction of travel, or

2. Whether F0 is on or off, or

3. Both direction of travel and whether F0 is on or off, or

4. Whether the locomotive is stopped or moving.

Programming Ditch Lights

To program your decoder for alternating ditch lights use the following CVs:

CV51 = 106, CV52 = 107, CV63 = 64. The ditch lights are wired to the F1 and

F2 outputs for this.

Function Remapping

Function remapping allows you to program the function outputs of your

decoder to be controlled by selected function keys on your throttle. Please

consult the Digitrax Decoder Manual or website for information on function

remapping.

Master Light Switch

Each of the four function outputs can be programmed to turn on and off with

the F0 ON/OFF key on your throttle, creating a Master Light Switch. The CV

values for creating this effect are listed in the Digitrax Decoder Manual in the

section: Setting Up FX & FX

Complete Train Control

Run Your Trains, Not Your Track!

Effects on Function Outputs.

www.digitrax.com

lighting effects