Digitrax SD40T-2/ Посібник із швидкого старту - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Іграшка Digitrax SD40T-2/. Digitrax SD40T-2/ 8 сторінок.
Друкувати сторінку
Parts List
1 DN166I0 Mobile Decoder
Installation Information
See the Digitrax Decoder Manual for complete decoder test procedures, instal-
lation instructions, programming and technical information. Digitrax manuals
and instructions are updated periodically. Please visit www.digitrax.com for the
latest versions, technical updates and additional locomotive-specific installation
instructions. CAUTION: Programming and layout track must not exceed
16V when using this decoder.
Installation Instructions
1.
Carefully remove the
locomotive's shell from the
frame. Notice the orien-
tation of the light board
inside so that you can
install the decoder in the
same orientation.
2.
Carefully remove the plas-
tic light shroud at the front
of the loco and loosen the
frame screws enough to
allow the removal of the
light board. Lift the board
out of the frame.
3.
Apply the Kapton insu-
lating tape on the front of
frame to completely cover
the flat area above the
frame screw. Install the
decoder, square CPU on
the bottom, between the
frame halves. The narrow
part of the decoder fits be-
tween the frame with the
frame clips holding it at
the corners of the decoder
cutout. The brass motor
contacts should contact
the pads on the bottom of
the decoder. The motor
contacts can also be in-
© 2014 Digitrax, Inc.
Light
shroud
Factory Light board
Figure 1: Remove loco shell
Motor Contacts
Figure 2: Loosen frame screws and remove light
board
Replace Light Shrouds
Figure 3: Place decoder in frame.
— 2 —
1 Instruction Sheet
Frame Screws
Apply Insulating
Frame Clips
Tape Here
Apply Kapton
Insulating Tape
Here
www.digitrax.com
Light
shroud