Digitron 1100D Інструкція з експлуатації - Сторінка 17
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Термометр Digitron 1100D. Digitron 1100D 18 сторінок.
Друкувати сторінкуLogging Parameters 1100D Only (continued)
1.
To change the logging stop time, press and hold the MENU key
down to activate menu mode until the 1100D beeps and "EDIT" is
displayed.
2.
Press the menu key repeatedly until logger start time mode is dis-
played. See below.
3.
To set the stop time press the RIGHT ARROW key to set the desired
value in seconds. Holding the key down will increase the value
rapidly. Press the LEFT ARROW key and the minute's d i g i t s will
blink. Press the RIGHT ARROW key to set the desired value. Press
the LEFT ARROW key to cycle to the hour digits. Press the RIGHT
ARROW key to set the desired value.
4.
After the desired stop time is set press the MENU key to go to the
next selection or press and hold the MENU key to exit menu mode.
32
Logging Parameters 1100D Only (continued)
1.
To enable (reserve) the logging function to begin at the specified
start time, press and hold the MENU key down to activate menu
mode until the 1100D beeps and "EDIT" is displayed.
2.
Press the menu key repeatedly until logger reserve mode is
displayed. See below.
3.
Pressing the RIGHT ARROW key enables (LrES yes) or disables
(LrES no) reserved logging.
4.
After the desired reserved mode is set press the MENU key to go to
the next selection or press and hold the MENU key to exit menu
mode.
33