Cisco RSP4+ Посібник з встановлення та налаштування - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник з встановлення та налаштування для Мережеве обладнання Cisco RSP4+. Cisco RSP4+ 20 сторінок. Bootflash memory upgrade to 16mb

Друкувати сторінку

Installing the RSP4+

Follow the steps below to reinstall the RSP4+ that was removed.

Step 1

Hold the RSP4+ handle with one hand and place your other hand under the carrier to support the

RSP4+ and guide it into the slot. (See Figure 2.) Avoid touching the card or any connector pins.

To prevent ESD damage, handle the RSP4+ by the handles and carrier edges only.

Caution

Place the back of the RSP4+ in the slot and align the notch on the carrier with the groove in the slot.

Step 2

(See Figure 1.)

While keeping the RSP4+ parallel to the backplane, carefully slide it into the slot until the back of the

Step 3

faceplate makes contact with the ejector levers, and then stop. (See b in Figure 1.)

Caution

Use the ejector levers to remove or install the RSP4+. Failure to do so can cause erroneous

system error messages indicating a board failure.

Step 4

Using your thumbs, simultaneously push both ejector levers inward until the RSP4+ is pushed entirely

into its slot. (See c in Figure 1.)

Tighten both captive installation screws.

Step 5

Reconnect the cables to the RSP4+.

Step 6

This completes theRSP4+ installation procedure.

Loading and Configuring the Bootflash Image

Using the steps in this procedure, you will:

•

78-12288-02

Enable the router to enter privileged mode

Confirm the new bootflash size

Format the bootflash

Copy the rsp-boot image onto the bootflash

Confirm that the image has been copied to bootflash

Modify the configuration file to reboot using the new bootflash image

Configure the router to use the bootloader image in bootflash

Save the configuration

Confirm that the configuration reflects the new bootloader image

RSP4+ Bootflash Memory Upgrade to 16MB Installation and Configuration Guide

Installing the RSP4+