Cisco RSP7000 Встановлення - Сторінка 17

Переглянути онлайн або завантажити pdf Встановлення для Мережеве обладнання Cisco RSP7000. Cisco RSP7000 26 сторінок. Upgrade kit in the cisco 7000 series routers
Також для Cisco RSP7000: Посібник з встановлення та налаштування (48 сторінок)

Друкувати сторінку

Removing the RP

Follow these steps to remove the RP:

Caution

component. Removing a RP while the system is operating will cause the system to shut down or

crash and might damage or destroy memory ﬁles.

Step 1

Step 2

Step 3

Step 4

Figure 8

Captive

installation screw

Upper

power supply

Captive

installation screw

Lower

power supply

You must shut down the system before removing the RP, which is a required system

Upload (copy) the currently running conﬁguration ﬁle to a TFTP server so you can retrieve

it later. (See the section "Saving and Retrieving the Conﬁguration File" on page 11.)

Slip on an antistatic strap and connect the equipment end of the strap to a captive

installation screw on an installed interface processor, or to any unﬁnished chassis surface.

Disconnect any devices that are attached to the console or auxiliary ports on the RP.

Locate the RP in your chassis. The SP (or SSP) is installed in slot 5 in the Cisco 7000 (see

Figure 8) or slot 3 in the Cisco 7010 (see Figure 9).

Cisco 7000 with RP and SP (or SSP) Installed

Installing the RSP7000 Upgrade Kit in the Cisco 7000 Series Routers

Slot 0

SSP

slot

Installing the RSP7000 Upgrade Kit

slot