Cisco SCE 1000 and Посібник із швидкого старту - Сторінка 16
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання Cisco SCE 1000 and. Cisco SCE 1000 and 49 сторінок. Service control engine 1000 2xgbe
Друкувати сторінку
Table 1
Setup Command Parameters (continued)
Parameter
link bypass mode on operational status
link bypass mode on non-operational status
priority
(cascade topology only)
operational status of the SCE after abnormal boot
Following are some general instructions regarding the setup dialog:
• All default values appear in square brackets [default].
If no value appears in the brackets [], or more than one option appears [yes/no], then this parameter does not have a default
value.
• To accept the default value, press Enter.
• If you need more information about any parameter, type? and press Enter.
A help message will appear describing the expected format of the parameter and any other requirements.
• To jump to the end of the setup dialog at any point, accepting all remaining default values, press ^z.
• In certain cases, there will be two or more logically related parameters within a menu. In these situations, it is not permitted
to jump to the end of the setup dialog until all related parameters are configured. If you try to jump to the end of the setup
dialog, the following message will appear:
• Certain groups of related parameters, such as time, date, and SNTP settings, form sub-dialogs or menus within the setup
dialog. You may skip an entire menu, thereby accepting all default values for the parameters within the menu.
Each group of related parameters is prefaced by a question, asking whether you want to enter the menu. To skip the menu,
answer no ("n") to the question.
Example
Would you like to enter the SNMP configuration menu? n
• To abort the setup dialog at any point without making any configuration changes, press ^c. All changes already entered will
be lost, with the exception of time settings.
Step 1: Configuring Initial Settings
Verify the following initial settings for the SCE 1000:
• IP address
• Subnet mask
• Default gateway
All values are Internet addresses of the form 'X.X.X.X', where each letter corresponds to a decimal number between 0 and 255.
Configure the IP address.
Step 1
The current IP address is displayed.
To accept the displayed value, press Enter.
–
To change the value, type the desired value in the format "x.x.x.x" and press Enter.
–
16
Definition
When the SCE 1000 is operational, should it bypass traffic or not?
When the SCE 1000 is not operational, should it bypass traffic or cut it
off?
If this is a cascaded topology, is this SCE 1000 the primary or secondary
SCE 1000?
After a reboot due to a failure, should the SCE 1000 remain in a Failure
status or move to operational status provided no other problem was
detected?
"Sorry, Skipping is not allowed at this stage."