Cisco SCE 1000 and Посібник із швидкого старту - Сторінка 33

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання Cisco SCE 1000 and. Cisco SCE 1000 and 49 сторінок. Service control engine 1000 2xgbe

Друкувати сторінку

Cisco SCE 1000 and Посібник із швидкого старту

Save the configuration to a remote location.

Step 5

If the configuration was applied and saved, you may also save a backup copy to a file at a remote station.

Do you want to save a copy of the startup configuration file in a remote station? [no]:

To save the configuration to a remote station, type

The system will ask for FTP path:

Enter a full FTP path of the remote destination:

This completes the procedures for initial configuration of the SCE 1000 platform.

Step 6

The system informs you that the configuration is complete.

Committing configuration...

Configuration completed successfully.

Saving configuration...

Writing general configuration file to temporary location...

Backing-up general configuration file...

Copy temporary file to final location...

Done!

Examples

• Example 1:, page 33

• Example 2:, page 33

• Example 3:, page 34

Example 1:

Following is an example of a configuration that the user aborted due to errors detected in the configuration.

Note that no confirmation is requested for the decision to abort the setup. Had there been no errors, confirmation would have

been requested before aborting.

Data collection for the system configuration is completed.

Would you like to view the new configuration before it is applied? [yes/no]: n

Found errors in the new configuration, would you like to view them? [yes]: y

The following errors were found:

Warning - RDR formatter destination 10.1.1.1 is not allowed in the IP access-class.

Warning - default Gateway 10.1.1.1 is not allowed in the IP access-class.

Warning - IP Access list (1) conflicts with Telnet Access list (2) as follows:

Access list 2 permits all addresses while Access list 1 denies it.

Apply and Save this configuration? [yes/no]: n

Setup procedure aborted, no configuration changes made.

Example 2:

Following is an example of a configuration that was applied and saved to the startup configuration as well as to an FTP site.

Although not demonstrated in this example, it is recommended that you always view the configuration before applying it.

Data collection for the system configuration is completed.

Would you like to view the new configuration before it is applied? [yes/no]:

Apply and Save this configuration? [yes/no]: y

(New configuration would be displayed here)

The running configuration would be overwritten by the changes you have just entered, are you sure? [yes/no]:y

The new running configuration will be saved to the startup configuration.

Do you want to save a copy of the startup configuration file in a remote station? [no]:y

Enter a full FTP path of the remote destination: ftp://vk:[email protected]/h:/copyofstartup.txt