Cisco SCE 1000 and Посібник із швидкого старту - Сторінка 40
Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Мережеве обладнання Cisco SCE 1000 and. Cisco SCE 1000 and 49 сторінок. Service control engine 1000 2xgbe
Друкувати сторінку
To view the running configuration, use the following command:
At the SCE 1000# prompt, type show running-config.
Step 1
The system shows the running configuration.
SCE 1000number show running-config #This is a general configuration file (running-config).
#Created on 15:50:56 CET MON December 11 2005
#cli-type 1
#version 1
clock timezone CET 1
snmp-server community "public" ro
snmp-server host 10.1.1.253 traps version 1 "public"
interface LineCard 0
connection-mode active
no silent
no shutdown
flow-aging default-timeout UDP 60
interface FastEthernet 0/0
ip address 10.1.5.109 255.255.0.0
interface FastEthernet 0/1
interface FastEthernet 0/2
exit
line vty 0 4
no timeout
exit
SCE 1000number
Saving the Configuration Settings
When you make changes to the current running configuration and you want those changes to continue to be valid when the
system restarts, you must save the changes before leaving the management session, that is, you must save the running
configuration to the startup configuration file.
The SCE platform provides multiple interfaces for the purpose of configuration and management. All interfaces supply an API
to the same database of the SCE platform and any configuration made through one interface is reflected through all interfaces.
Furthermore, when saving the running configuration to the startup configuration from any management interface, all
configuration settings are saved regardless of the management interface used to set the configuration.
To save configuration changes, complete the following steps:
At the SCE 1000# prompt, type
Step 1
The running configuration is displayed.
Step 2
Check the displayed configuration to make sure that it is set the way you want. If not, make the changes you want
before saving.
Type copy running-config startup-config.
Step 3
The system saves all running configuration information to the configuration file, which is used when the system reboots.
The configuration file holds all information that is different from the system default in a file called config.txt located
in the directory: tffs0:system.
40
to view the running configuration.
show running-config