Cisco 700 series Посібник для початківців - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник для початківців для Сервер Cisco 700 series. Cisco 700 series 27 сторінок. Using profiles
Також для Cisco 700 series: Посібник із швидкого старту (8 сторінок), Огляд (19 сторінок), Посібник користувача (9 сторінок), Посібник з адміністрування (36 сторінок)

An access point sends all syslog messages to IP address 255.255.255.255 by default when any of the following conditions are

met:

• An access point running software release 5.2 or later has been newly deployed.

• An existing access point running software release 5.2 or later has been reset after clearing the configuration.

If any of these conditions are met and the access point has not yet joined a controller, you can also configure a DHCP server to

return a syslog server IP address to the access point using option 7 on the server. The access point then starts sending all syslog

messages to this IP address.

When the access point joins a controller for the first time, the controller sends the global syslog server IP address (the default is

255.255.255.255) to the access point. After that, the access point sends all syslog messages to this IP address until it is

overridden by one of the following scenarios:

• The access point is still connected to the same controller, and the global syslog server IP address configuration on the

controller has been changed using the config ap syslog host global syslog_server_IP_address command. In this case, the

controller sends the new global syslog server IP address to the access point.

• The access point is still connected to the same controller, and a specific syslog server IP address has been configured for the

access point on the controller using the config ap syslog host specific Cisco_AP syslog_server_IP_address command. In this

case, the controller sends the new specific syslog server IP address to the access point.

• The access point is disconnected from the controller and joins another controller. In this case, the new controller sends its

global syslog server IP address to the access point.

• Whenever a new syslog server IP address overrides the existing syslog server IP address, the old address is erased from

persistent storage, and the new address is stored in its place. The access point also starts sending all syslog messages to the

new IP address provided the access point can reach the syslog server IP address.

You can configure the syslog server for access points and view the access point join information only from the controller CLI.

A detailed explanation of the join process is on Cisco.com at the following URL:

http://www.Cisco.com/en/US/products/ps6366/products_tech_note09186a00808f8599.shtml

Declarations of Conformity and Regulatory Information

This section provides declarations of conformity and regulatory information for Cisco Aironet 700 Series Access Points. You

can find additional information at this URL:

www.cisco.com/go/aironet/compliance

Manufacturers Federal Communication Commission Declaration of Conformity

Statement

Models

AIR-CAP702I-A-K9

AIR-SAP702I-A-K9

Certification Numbers

LDK102085