Cisco APIC M4 Посібник з монтажу та обслуговування - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник з монтажу та обслуговування для Сервер Cisco APIC M4. Cisco APIC M4 46 сторінок.

Overview

• Riser 1—Supports Riser1. Supports single x16 PCIe supporting full height 3/4 length cards in 2 riser

configuration (or) Half-height 3/4-length cards in 3 riser configuration and NC-SI from Pilot4.

• Riser 2—Supports Riser 1. Supports single x16 PCIe supporting only Half-height 3/4-length cards in

3-riser configuration.

• Riser 3—Supports Riser 3A, 3B. PCIe slot 3 with the following options:

• Riser3A Supports single x16 PCIe supporting half height 3/4 length cards in 3 riser configuration

• Riser3B Supports single x16 PCIe supporting full height 3/4-length cards in 2 riser configuration

• 2 10GBase-T Ethernet LAN over Motherboard (LOM) ports for network connectivity, plus one 1 Gigabit

Ethernet dedicated management port.

• One mLOM/VIC card provides 10G/25G/40G/50G/100G connectivity. Supported cards are:

• Cisco UCS Vic15428 Quad Port CNA MLOM (UCSC-M-V5Q50G) supports:

• a x16 PCIe Gen4 Host Interface to the rack server

• four 10G/25G/50G SFP56 ports

• 4GB DDR4 Memory, 3200 MHz

• Integrated blower for optimal ventilation

• Cisco UCS Vic1477 Dual Port 40/100G QSFP28 (UCSC-M-V100-04)

• a x16 PCIe Gen3 Host Interface to the rack server

• two 10G/25G QSFP28 ports

• 2GB DDR3 Memory, 1866 MHz

• Cisco UCS Vic1467 Quad Port 10/25G SFP28 mLOM (UCSC-M-V25-04) supports:

• a x16 PCIe Gen3 Host Interface to the rack server

• four 10G/25G QSFP28 ports

• 2GB DDR3 Memory, 1866 MHz

Note

The following limitations apply to the Cisco APIC Server M4 and L4:

• Cluster formation isn't supported for UCSC-PCIE-C25Q-04.

• 25 link is not supported with Intel NIC E810XXVDA2 2x25/10 GbE SFP.

• Cisco APIC Server M4-L4 using Intel NIC X710 should always be used with 10G supported copper

Cisco APIC M4/L4 Server Installation and Service Guide

and NC-SI.

switch.

Overview