Epson ActionLaser 1600 Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Сканер Epson ActionLaser 1600. Epson ActionLaser 1600 10 сторінок. Epson actionlaser 1600: quick start
Також для Epson ActionLaser 1600: Прочитайте цей перший посібник (26 сторінок), Специфікація продукту (2 сторінок)
Друкувати сторінку
To install a SIMM:
1. Hold the SIMM as shown below and insert it into the slot
at an angle as shown below. Make sure the pin number of
both the slot and the SIMM matches, showing 1 or 72.
2. Press the SIMM in firmly, in the direction shown in the
illustration, until it snaps into the notch of the connector.
Do not apply too much force.
3. Reinstall the controller board as shown in the next section.
Reinserting the controller board
1. Hold the controller board level and fit its right edge into
the right groove inside the board slot. Then gently tit its
left edge into the left groove.
2. Slide the controller board into the printer until it locks in
place. If the controller board does not fit smoothly into the
printer, do not force it. Remove it and make sure the
edges tit properly into the grooves inside the slot.
3. Secure the board with the three silver screws you removed
earlier.
Laser Printers
Attach the interface board cover with the two screws you
removed earlier.
Note:
Do not attach the interface cover if an optional interface is
installed.
Reconnect any interface cables you removed
Insert the interface cable or cables into the U-shaped part of
one cable clip. Lift the left side of the printer up slightly.
Then hook the short lip of the clip into the forward slot
and push the bottom of the clip under the printer until it
clicks in place. Repeat this procedure with the second clip
and insert it into the back slot.
Be sure the power is turned off, then plug the power cord
into an electrical outlet.
Checking the memory
Turn on the printer. When the RAM Check message appears,
make sure the printer displays the total amount of RAM that
you now have installed, including the 2MB of standard
memory.
If an incorrect amount appears, turn off the printer and
remove the controller board. Make sure you installed each
SIMM in the correct direction and that it is fully seated. If the
RAM Check message is still incorrect, contact your dealer or
a qualified service person for assistance.
Option Specifications
Face-up output tray
Dimensions and
weight:
Paper eject
capacity :
5/10/94
EPSON ActionLaser 1600
Without the printer:
Height
47 mm (1.7 inches)
Width
251 mm (9.9 inches)
Depth
275 mm (10.8 inches)
Weight
0.1 kg (0.2 lb)
2
20 sheets (80 g/ m
)
AL1600-5