Cisco Firepower 2110 Посібник - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник для Сервер Cisco Firepower 2110. Cisco Firepower 2110 12 сторінок. Rack-mount and ground the chassis
Також для Cisco Firepower 2110: Посібник з програмного забезпечення (37 сторінок), Посібник з розгортання (8 сторінок), Початок роботи (42 сторінок)

Rack-Mount the Chassis Using Brackets

This procedure describes how to install the Firepower 2100 in a rack using the rack-mount brackets. It also

describes how to install the optional cable management brackets. See

PIDs associated with rack-mounting the chassis.

The rack is a standard Electronic Industries Association (EIA) rack. It is a 4-post-EIA-310-D, which is the

current revision as specified by EIA. The vertical hole spacing alternates at .50 inches (12.70 mm) to .625

inches (15.90 mm) to .625 inches (15.90 mm) and repeats. The start and stop space is in the middle of the

.50-inch holes. The horizontal spacing is 18.312 inches (465.1 mm), and the rack opening is specified as a

minimum of 17.75 inches (450 mm).

You need the following to install the Firepower 2100 in a rack:

• Phillips screwdriver

• Two rack-mount brackets (part number 700-106374-01) with six 8-32 x 0.281-inch screws (part number

• Rack-mount screws:

• (Optional) Cable management bracket kit (part number 69-100376-01):

Step 1

Attach a rack-mount bracket to each side of the chassis using the six 8-32 x 0.281-inch Phillips screws (three per side).

Rack-Mount and Ground the Chassis

48-101518-01)

Note

The rack-mount brackets ship with the Firepower 2110/2120 and are orderable

for the Firepower 2130/2140.

Note

The rack-mount screws ship with the Firepower 2110/2120 and are orderable for

the Firepower 2130/2140.

• Four 12-24 x 0.75-inch Phillips screws (part number 648-0440-01) for securing the chassis to your

rack

• Four 10-32 x 0.75-inch Phillips screws (part number 48-0441-01) for securing the chassis to your

rack

• Four M6 x 1 x19-mm Phillips screws (part number 48-101022-01) for securing the chassis to your

rack

• Two cable management brackets (part number 700-106377-01)

• Four 8-32 x 0.375-inch Phillips screws (part number 48-2696-01)

Rack-Mount and Ground the Chassis

Product ID Numbers

for a list of the