Cisco Firepower 2140 Посібник - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник для Сервер Cisco Firepower 2140. Cisco Firepower 2140 12 сторінок. Rack-mount and ground the chassis
Також для Cisco Firepower 2140: Посібник з розгортання (8 сторінок), Початок роботи (42 сторінок), Встановлення та обслуговування (26 сторінок)

Rack-Mount and Ground the Chassis

Step 3

Attach the inner rails to the sides of the chassis:

a) Remove the inner rails from the slide rail assemblies.

b) Align an inner rail with each side of the chassis:

• (2110/2120) Install three 8-32 x 0.25-inch Phillips screws into each side of the chassis, and align the inner rail

so that the three slots on the rail line up with the screws on the chassis.

Figure 5: Line up the Inner Rail and Install the Screws on the 2110/2120 Chassis

8-32 x 0.25-inch Phillips screws (3 per side)

Inner rail

• (2130/2140) Align the inner rail so that the three slots on the rail line up with the three pegs on the side of the

chassis.

Figure 6: Line up the Inner Rail with the Pegs on the 2130/2140 Chassis

Mounting peg on the chassis for the keyed slot

Inner rail

c) Set the keyed slots over the screws/pegs, and then slide the rail toward the front to lock it in place on the screw/pegs.

The rear key slot has a metal clip that locks over the screw/peg.

d) Using one M3 x 6-mm Phillips screw, secure the inner rail to the side of the chassis to prevent sliding.

e) Install the second inner rail to the opposite side of the chassis and secure with the other M3 x 6 mm screw.

Rack-Mount the Chassis Using Slide Rails

M3 x 6 mm-Phillips screw (one per side)

—

M3 x 6 mm-Phillips screw (one per side)

—

Rack-Mount and Ground the Chassis