B2 Mono Quattro Посібник користувача - Сторінка 4
Переглянути онлайн або завантажити pdf Посібник користувача для Підсилювач B2 Mono Quattro. B2 Mono Quattro 10 сторінок. High performance amplifiers
Друкувати сторінкуHIGH PASS FILTER ( 50Hz ~ 1KHz @ 12dB/Oct )
Adjusts the cut off point for the high pass filter.
The wide frequency range allows for "Active" speaker
operation.
CROSSOVER SELECTOR
Configuration of the filter mode. HPF/FULL/LPF.
Mono & Quattro
3-3.
GND ( GROUND CONNECTION )
For connection to the chassis' ground.
For optimum performance 0 gauge cable is
recommended.
+12V ( POWER CONNECTION )
For connection to the positive terminal of the
battery (+12). For optimum performance
0 gauge cable is recommended.
4. INSTALLATION
If you chose to install the
Before you start your installation, please take all steps into consideration. Otherwise, please go to
www.b2-audio.com for authorized distributors or contact us directly for support.
4-1. MOUNTING PREPARATION
Disconnect the negative ( ) battery cable before mounting
Check the battery and alternator ground ( ) connections.
Make sure they are properly connected and free of corrosion. Before selecting a mounting location
for the amplifier, please take cooling and safety into consideration.
4-2. MOUNTING PREPARATION
B2
amplifiers have been designed with a good heat radiation heatsink to avoid excessive heat
from the amplifier circuitry. For optimum heat radiation performance, it is recommended to
find a mounting location that allows for vertical installation of the heat sink fins.
CONTROL & CONNECTION
B2
series by yourself, please read the owners' manual carefully.
LOW PASS FILTER ( 30Hz ~ 300Hz @ 12dB/Oct )
Adjusts the cut off point for the low pass filter.
REMOTE LEVEL CONTROL PORT
Connection of external level control.
REM ( REMOTE )
Connect to switched +12V with trigger from head unit.
SPEAKER OUTPUTS
Amplifier connection to loudspeakers.
Minimum speaker cable is 12 gauge.
Mono
minimum impedance is 1 ohm if used as
a single unit.
Mono
in linked mode offers stable opearation to
a minimum of 2 ohms.
Quattro
minimum impedance is 2ohms stereo or
4 ohms mono
B2
series or making any connections.
3