Cisco Nexus 7000 Series Посібник із швидкого старту - Сторінка 6

Replacing a DIMM on an I/O Module

Step 16

Step 17

Step 18

Step 19

Step 20

Step 21

Related Documentation

Release Notes

NX-OS Configuration Guides

Replacing Memory on a Cisco Nexus 7000 Series I/O Module

Align the module to the open I/O slot in the chassis and push the module into the

slot until it makes contact with the midplane.

Simultaneously push both ejector levers inward until they come in contact with

the face of the module.

The module should be fully seated in the slot and the captive screws should be

aligned with their holes in the chassis. The EMI gasket should close the gap

between this module and the next module.

Screw in the two captive screws to the chassis and tighten them to 8 in-lb (0.9

Nm).

Reconnect the copper (1000BASE-T) and fiber-optic (SFP, SFP+, FET, and X2)

I/O modules as explained in the "Connecting an I/O Module" section of the Cisco

Nexus 7000 Series Hardware Installation and Reference Guide.

Verify that the module has 8 GB of memory by using the show system resources

command.

If you need to replace the DIMM on another Cisco Nexus 7000 Series I/O module,

repeat Steps 2 through 18.

Cisco NX-OS documentation is available at the following URL:

http://www.cisco.com/en/US/products/ps9372/tsd_products_support_series_ho

me.html

The Release Notes for upgrading the FPGA/EPLD is available at the following

URL:

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/sw/6_x/epld/epld_rn_

62.html

Cisco Nexus 7000 Series NX-OS Release Notes, Release 6.x

Cisco Nexus 2000 Series Fabric Extender Software Configuration Guide

78-100406-01